wifinigel Posted February 22, 2016 Share Posted February 22, 2016 Hi, I've followed the FAQ process to factory reset my Tetra (push button for 7 secs / Factory default from GUI), but it refuses to return to factory default. The best I can achieve is a reboot, but all data is still intact. Is there a CLI method to achieve this? Thanks Nigel. Link to comment Share on other sites More sharing options...
Sebkinne Posted February 22, 2016 Share Posted February 22, 2016 Interesting. You should be able to SSH / Serial into your TETRA and issue the "firstboot" command. You'll need to confirm with a "y" and execute the "reboot" command afterwards, if it doesn't happen automatically. I'll investigate this issue and see if it's a bug. Best Regards, Sebkinne Link to comment Share on other sites More sharing options...
wifinigel Posted February 22, 2016 Author Share Posted February 22, 2016 Thanks, that seems to have done the job. Nigel. Link to comment Share on other sites More sharing options...
shadowmmm Posted February 23, 2016 Share Posted February 23, 2016 can confirm went to configuration tab on tetra firmware 1.0.2 .clicked the General down arrow. selected Factory Restore PineApple and nothing happend the first time. Also unable to install dnsSpoof 1.2 it freezes on installing for 25min Link to comment Share on other sites More sharing options...
Brian3656 Posted February 28, 2016 Share Posted February 28, 2016 I noted slow/no loading of modules the other day, I walked away for a couple hours then attempted again. I began to retry some of the modules and low and behold every thing loaded. I have a sneaking suspicion the whole issue might be related to the problem with the openwrt hosting site. Link to comment Share on other sites More sharing options...
Cr33d Posted October 8, 2019 Share Posted October 8, 2019 hello can you help me , am trying to reset my tetra because i forgot my initial setup password, when i use cli it still requests the password, how do i do a complete factory reset, and yes have tried holding 7 sec to no success , all it ends up doing is just rebooting.. thanks in advance Link to comment Share on other sites More sharing options...
Irukandji Posted October 8, 2019 Share Posted October 8, 2019 On the doc page. https://docs.hak5.org/hc/en-us/articles/360010555853-Factory-Reset Quote Factory Reset Settings may be restored to defaults using the factory reset procedure. This process will restore the device to the initial configuration of the latest installed firmware. Upon performing the factory reset procedure initial setup must be performed, setting the root password and SSID. To perform a factory reset from a fully booted WiFi Pineapple, hold the RESET button for approximately 7 seconds. The device will then reboot. Link to comment Share on other sites More sharing options...
Cr33d Posted October 10, 2019 Share Posted October 10, 2019 On 10/8/2019 at 11:47 AM, Jtyle6 said: On the doc page. https://docs.hak5.org/hc/en-us/articles/360010555853-Factory-Reset does not work, it just restarts but still retains all info no reset Link to comment Share on other sites More sharing options...
Cap_Sig Posted October 17, 2019 Share Posted October 17, 2019 On 10/10/2019 at 1:14 PM, Cr33d said: does not work, it just restarts but still retains all info no reset Need to do a firmware recovery. https://docs.hak5.org/hc/en-us/articles/360010471774-Firmware-Recovery Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.