Hacker_213 Posted October 30, 2019 Share Posted October 30, 2019 I have a bash bunny that has not been used in about 5 months. I pulled it back out and it wouldn't allow access via arming mode. I preformed the reset according to the instructions, I see the red/blue flashing lights that go on for about 3-5 minutes. When completed I am getting the following blink code with the device set to arming. Green Solid Red Blue Red Blue Red Then it appears to reset itself and goes back to the initial Green light again. I have tried the recovery process on both a windows 10 as well as a mac system and I am getting the same results, any help would be greatly appreciated. Quote Link to comment Share on other sites More sharing options...
Hacker_213 Posted October 30, 2019 Author Share Posted October 30, 2019 Was able to recover with Quote Link to comment Share on other sites More sharing options...
Cap_Sig Posted November 1, 2019 Share Posted November 1, 2019 Glad to hear. Good use of the forum 👍 Quote Link to comment Share on other sites More sharing options...
INFOTRACE Posted November 3, 2019 Share Posted November 3, 2019 On 10/30/2019 at 3:14 PM, Hacker_213 said: Was able to recover with Thanks for sharing buddy........one for the Bookmarking page.......😎 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.