Jump to content

Recon Scan Problems


b0N3z

Recommended Posts

Ive factory reset and firmware recovery on my tetra with firmware 2.4.2.  After a power down or reset and power back on, Ill go into recon tab and run a 2min scan on both frequencies.  The very first scan never shows results.  I have to load the scan from the Scan Results section.  After the first scan everything works fine.  Im doing this with no other modules installed or anything done to the tetra besides starting fresh.  This happens with LIVE scan selected and LIVE scan deselected.  It doesnt matter what amount of time I put on the scan or the frequency I select.  I have done a firmware recovery 3x and factory reset about 2x between each firmware recovery.  Any ideas on what is going on?  @Sebkinne @Foxtrot

 

Link to comment
Share on other sites

  • 4 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...