Jump to content

My bashbunny will not update


levic08

Recommended Posts

I tried updating my bashbunny to 1.4 today, and it was going well.. Then, after i ejected it and put it back in to start the update it started flashing a "police" pattern. I am back on version 1.0 and no matter what update i download, i am not able to go up. I would really like some help... I don't understand what is wrong.

Link to comment
Share on other sites

do a factory reset by plugging it in and unplugging after the initial green light.  then try again. remember the bunny is so simple all you have to do is download the firmware upgrade and drag and drop to the mass storage in arming mode.  unplug and then plug back in.  The "police" pattern means its updating.  dont unplug it.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...