Juicybitch88
-
Posts
19 -
Joined
-
Last visited
Posts posted by Juicybitch88
-
-
-
@odeon Did sent Serialnumber and all of it but still arguing that it is not found.. like i told in other tread it was purchased in Dealership in Germany.
-
On 5/6/2023 at 12:30 PM, odeon said:
Hi there @Juicybitch88
I had to get a replacement and hak5 were GREAT! it's all detailed here in this thread it was very easy.
@odeonIm Fighting with Hak5 Support already weeks and not getting further.. Im a German Pentester and did buy mines from Firewire-Revolutions Shop in Germany.
Support dont accept my Invoice.
-
I did buy mines from https://firewire-revolution.de @Darren Kitchen so their are only a German Dealership,
and did write the support. I have the same issue already a while.
Can´t updrade to 2.0 or higher. More than 1.0 and the Pineapple is Dead. Back to Firmware Flash like guided and the same game again.Have sent my Invoices and all i have. So now what.. 200€ Paperweight?
-
Im Writing here this Step by Step because i have tried several times to Reset the device and by uploading the latest Firmware at the Setup menü i get a Flash error. It did work a while but since then..
Step 1: Factory reset the Firmware as in Manual told.
Factory Reset..
Step 2: Put the IP back to Normal again.
Step 3:
In this case i put have tried the 1.0 and it works. 2.0 does not and all others. 2.1...
Trying to Automatically update the Firmware over WIFI does load the newest.. and crash.
Therefore i load not the 1.1.1..
But at 2.0 it crash.... what can i do?
With 1.1.1 it works..
After that updating into:
Crash!!
-
On 3/5/2023 at 10:50 AM, dark_pyrro said:
Im getting exactly this: Have uploaded the Recovery file and getting into the Setup Menü as normal. Then at uploading the "newest" Firmware it says Flash Failure..
On 3/5/2023 at 10:50 AM, dark_pyrro said:If you get flash errors when using a 2.x firmware version, the Pineapple may have bad flash storage (something that is checked when 2.x fw is used). This means that you may have been running the Mark VII successfully on fw 1.x, but when upgrading to 2.x flash errors may be detected. If so, I would suggest creating a support ticket.
On 1.0 it runs but updating the Firmware runs into Problems..
-
Why do i get http://www.msftncsi.com/ncsi.txt message
and no other results..
-
You can check out a video on Youtube of Hack five as they did put several antennas in a Box and did Harvester a tons of SSIDs for a Long range.
With my normal antennas i get a signal from 5km away when it runs long enough.. 48 hours.
[RELEASE] WiFi Pineapple 2.1.3
in WiFi Pineapple
Posted · Edited by Juicybitch88
No answer at all @Darren Kitchen I cant update the Pineapple further then 1.0 Stable. After that it will crash.. is there anything i can do or do i have to get back to TP-Link USB stick?
My device:
Ralink Technology, Corp. MT7601U Wireless Adapter