siftyy Posted July 10, 2014 Share Posted July 10, 2014 Just after a fresh install of 1.4.1 I haven't been able to fine ANY networks on wlan1, has this happened to anyone else and is there a fix? Quote Link to comment Share on other sites More sharing options...
Sebkinne Posted July 11, 2014 Share Posted July 11, 2014 That's quite the odd behavior. You may want to follow our "Unbricking a bricked WiFi Pineapple MKV" instructions to see if that gets you up and running again. If that doesn't solve the issue, please update this thread and we can see about debugging the issue. Best Regards, Sebkinne Quote Link to comment Share on other sites More sharing options...
WPA3 Posted July 11, 2014 Share Posted July 11, 2014 Been having the same issue forma few days now, the other bad thing i have found it wont connect to some wifi access points even when few days before it. Sadly i aint had the time to try an reflash it Quote Link to comment Share on other sites More sharing options...
GnomeProgramming Posted July 11, 2014 Share Posted July 11, 2014 This happens to me some times... It tells me that there are not networks but I just click again and again and again then I would get the networks, tho this is weird to happen I normally don't have problems with that. And yeah it has happen to me in all browsers, so it's not a browser issue. Oh another think, are you using the original antennas? Because I got this error once, I plug an antenna (female) into my pineapple that its also female and of course I would never pick up signal cuz the antenna was never really contacted I figure out the error the next day when I just picked up wifi signal from few meters around. Quote Link to comment Share on other sites More sharing options...
Sebkinne Posted July 11, 2014 Share Posted July 11, 2014 If it happens once in a while and is fixed by hitting the scan link a few times, it is because the interface is in a "busy" state. It doesn't report this however, it simply returns no results when scanning. Not much I can do about it at this time. Make sure you have the correct (SMA, not RP-SMA) antennas connected too, otherwise there can be issues too. Otherwise, as I said, try a complete re-flash using the unbricking instructions. Best Regards, Sebkinne Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.