AMRITA TIFAC CYBER Posted November 5, 2019 Posted November 5, 2019 Hello everyone, I'm using wifi pineapple tetra and in my setup i'm able to run the dwall module but client url, images are not being displayed as output , ssl strip is not getting installed, clients are not getting connected. Please guide me to carry out the necessary attacks and other valuable advices for practising other attacks will also be useful for me :)
Cap_Sig Posted November 5, 2019 Posted November 5, 2019 Check here for module status: sslstrip currently requires a special install to work: If you are having an issue with clients connecting to the pineapple, make sure you have the whitelist/blacklist settings correct. Blacklist will allow all connections except those in the pool and opposite of this for whitelist. On the latest firmware you most likely have set it to whitelist clients.
AMRITA TIFAC CYBER Posted November 6, 2019 Author Posted November 6, 2019 thank you so much. i'll check this out and reply if there are any errors
Servant2000 Posted January 14, 2020 Posted January 14, 2020 I just bought my Tetra. I tried running DWalll... Doens't come to "Listening" stage and no activities are shown from connected clients.
Cap_Sig Posted January 14, 2020 Posted January 14, 2020 3 hours ago, Servant2000 said: I just bought my Tetra. I tried running DWalll... Doens't come to "Listening" stage and no activities are shown from connected clients. I think the module is still not fully updated to be compatible with firmware 2.6.x
Recommended Posts
Archived
This topic is now archived and is closed to further replies.