MrMice Posted July 21, 2018 Share Posted July 21, 2018 Hi, just got my nano and is trying to get it up and running. So far everything has worked out as planed but the internet sharing part of the video did not go smooth. I run the script as in the video. Using guided mode. After the run i checked if internet was shared and it was not. Ran it a gain loading config. Looks like it runs ok but in the end i can see this line from iptables: Too many links. And it allso looks like dns goes down on my machine. Using Linux Mint 19. Link to comment Share on other sites More sharing options...
b0N3z Posted July 22, 2018 Share Posted July 22, 2018 do you have your firewall enabled? Ive always had to disable my firewall to get it working on mint. Link to comment Share on other sites More sharing options...
MrMice Posted July 22, 2018 Author Share Posted July 22, 2018 Not turned it on by my self. But ill check if it's running as it's a fresh install. Thanks for the reply Link to comment Share on other sites More sharing options...
MrMice Posted July 23, 2018 Author Share Posted July 23, 2018 Firewall is off. looks like it the command "iptables -X" that fail whit the error. The script just continue if any of them fail and delete all routes in the table. Adjusted the script so it exit early but not sure what the error means yet as im new on iptables. Link to comment Share on other sites More sharing options...
MrMice Posted July 23, 2018 Author Share Posted July 23, 2018 There was a working fix for the script in a open pull request in the repo. It fixed my problems Link to comment Share on other sites More sharing options...
b0N3z Posted July 23, 2018 Share Posted July 23, 2018 pls post the fix so other can see it also, just in case anybody else has had the same problem. Link to comment Share on other sites More sharing options...
MrMice Posted July 25, 2018 Author Share Posted July 25, 2018 https://github.com/hak5darren/wp6/pull/4 Link to comment Share on other sites More sharing options...
riveck Posted August 16, 2019 Share Posted August 16, 2019 This indeed solved DNS issues on my Ubuntu 19.04 but only partially. Somehow my interface was showing a different IP than the one that comes by default on the nano: enx00c0caa7cb1c: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 172.16.42.194 netmask 255.255.255.0 broadcast 172.16.42.255 ether 00:c0:ca:a7:cb:1c txqueuelen 1000 (Ethernet) RX packets 2215 bytes 1445895 (1.4 MB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 2732 bytes 536442 (536.4 KB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 That is 172.16.42.194 instead of the expected 172.16.42.42. I changed the default route on the pineapple -> Networking -> Default route and it all went smoothly from there. Damn that was hard to find! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.