RichardNixon Posted July 30, 2016 Share Posted July 30, 2016 I can't even seem to connect to my new Nano there is no response on http://172.16.42.1:1471 I plug it in - it boots - blue light blinks - then goes solid ... My read of Ifconfig shows Nano is connected to en5 - but seems en5 has no IP address ??? Ifconfig output is below - and screen show is attached ... I'm stuck !!! Any ideas ? Is there a way to Hard Reset ?? ------------------------------------- en5: flags=8963<UP,BROADCAST,SMART,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu 1500 options=4<VLAN_MTU> ether 00:c0:ca:8f:b6:11 inet6 fe80::2c0:caff:fe8f:b611%en5 prefixlen 64 scopeid 0xa nd6 options=1<PERFORMNUD> media: autoselect (100baseTX <full-duplex,flow-control>) status: active bridge100: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500 options=3<RXCSUM,TXCSUM> ether 9a:e0:d9:79:10:64 inet 192.168.2.1 netmask 0xffffff00 broadcast 192.168.2.255 inet6 fe80::98e0:d9ff:fe79:1064%bridge100 prefixlen 64 scopeid 0xb Configuration: id 0:0:0:0:0:0 priority 0 hellotime 0 fwddelay 0 maxage 0 holdcnt 0 proto stp maxaddr 100 timeout 1200 root id 0:0:0:0:0:0 priority 0 ifcost 0 port 0 ipfilter disabled flags 0x2 member: en5 flags=3<LEARNING,DISCOVER> ifmaxaddr 0 port 10 priority 0 path cost 0 nd6 options=1<PERFORMNUD> media: autoselect status: active pineapple-setup-stuck.pdf Quote Link to comment Share on other sites More sharing options...
FreqANDY Posted July 30, 2016 Share Posted July 30, 2016 There is a hard reset on the bottom of the unit. Hold it in for about 10-15 seconds (i don't know the exact duration I just do it for this long) and resetup. The available video tutorials online make it extremely easy. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.