Jump to content

RichardNixon

Members
  • Content Count

    1
  • Joined

  • Last visited

About RichardNixon

  • Rank
    Newbie
  1. I can't even seem to connect to my new Nano there is no response on http://172.16.42.1:1471 I plug it in - it boots - blue light blinks - then goes solid ... My read of Ifconfig shows Nano is connected to en5 - but seems en5 has no IP address ??? Ifconfig output is below - and screen show is attached ... I'm stuck !!! Any ideas ? Is there a way to Hard Reset ?? ------------------------------------- en5: flags=8963<UP,BROADCAST,SMART,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu 1500 options=4<VLAN_MTU> ether 00:c0:ca:8f:b6:11 inet6 fe80::2c0:caff:fe8f:b611%en5 prefixlen 64 scopeid 0xa nd6 options=1<PERFORMNUD> media: autoselect (100baseTX <full-duplex,flow-control>) status: active bridge100: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500 options=3<RXCSUM,TXCSUM> ether 9a:e0:d9:79:10:64 inet 192.168.2.1 netmask 0xffffff00 broadcast 192.168.2.255 inet6 fe80::98e0:d9ff:fe79:1064%bridge100 prefixlen 64 scopeid 0xb Configuration: id 0:0:0:0:0:0 priority 0 hellotime 0 fwddelay 0 maxage 0 holdcnt 0 proto stp maxaddr 100 timeout 1200 root id 0:0:0:0:0:0 priority 0 ifcost 0 port 0 ipfilter disabled flags 0x2 member: en5 flags=3<LEARNING,DISCOVER> ifmaxaddr 0 port 10 priority 0 path cost 0 nd6 options=1<PERFORMNUD> media: autoselect status: active pineapple-setup-stuck.pdf
×
×
  • Create New...