Quintox Posted July 20, 2020 Share Posted July 20, 2020 Let me explain, every thing on the Nano side is good. Bulletin works, modules work. Ok. so I get out a Samsung Note 2 that is not activated, but wifi works. My open SSID on the Nano is AWHS, and on the phone it shows very strong signal. of course I am in same room When I clik to connect to my opened SSID, it gets an errror Authentication error occured. Anyone run into this problem. Link to comment Share on other sites More sharing options...
Quintox Posted August 1, 2020 Author Share Posted August 1, 2020 Problem fixed! To anyone else who happens to stumble across this page in the future, this solution comes from member "afraIT". I had originally set my NANO on "Allow" mode (for both options) when doing the initial setup. This turned out to be wrong and would cause the client to not be able to reach the internet once connected. RESOLUTION Preform a factory reset and choose "Deny" mode for both options instead of "Allow". (Fill in everything else as you normally would) I then connected to my NANO via the website, then connected the NANO to my internet (Networking page - WiFi Client Mode) Next, I did a brief Recon scan, added the "Scan Results" (there's a nice little drop-down arrow "Add all SSID's to PineAP Pool"), went to PineAP, checked all the boxes, enabled both options and saved the settings. Lastly, I used my iPhone to search for the local WiFi. Connected my iPhone to my NANO's AP successfully and was able to reach Google 🙂 (I also tried connecting this way with a Android as well; works) Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.