CuChulaind Posted December 16, 2018 Share Posted December 16, 2018 Just received a new Tetra. Went to the 1st time setup page, and I am greeting with the attached. Is this an older firmware version? It is not like my previous Tetra initial setup page. If so, how do I upgrade to the 2.4.2 version? When I click continue and I press the reset button, my old Tetra would automatically go to the next page. This one does not. The 3rd page I am asked to upload the update, my old one I was not, I was taken to the setup page. I point it to the latest firmware, press upgrade, and am taken to a success and wait page. 30 seconds later or so I am taken back to the upload page. What gives? Link to comment Share on other sites More sharing options...
CuChulaind Posted December 16, 2018 Author Share Posted December 16, 2018 Link to comment Share on other sites More sharing options...
Foxtrot Posted December 16, 2018 Share Posted December 16, 2018 This has been the same since the launch of the TETRA. Make sure you're specifying the correct firmware, and not a NANO firmware. Link to comment Share on other sites More sharing options...
CuChulaind Posted December 17, 2018 Author Share Posted December 17, 2018 The one from here: https://www.wifipineapple.com/downloads#tetra Link to comment Share on other sites More sharing options...
msbrks Posted December 19, 2018 Share Posted December 19, 2018 Hi. I got the same error. I did a Factory Reset following the FAQ procedure and it worked perfectly afterwards. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.