JwP Posted March 13, 2018 Share Posted March 13, 2018 I had an older nano that was working , but after i update the firmware to 2.02 it stopped allowing connections to the open wifi. I purchased a new unit and i was able to connect to the open wifi , bu when i went to configure the unit it forced me to update to the latest wifi and now it is doing the same thing as the older one. is there a problem with the firmware update going from ver 1 to ver 2? Link to comment Share on other sites More sharing options...
Foxtrot Posted March 13, 2018 Share Posted March 13, 2018 Hi JwP, You can solve this by connecting to the Management AP and setting the Filters to "Deny" with no filters listed. Link to comment Share on other sites More sharing options...
JwP Posted March 13, 2018 Author Share Posted March 13, 2018 Foxtrot, Thanks! it is working now. you would think the default would be setup to allow all .especially since it was not that way in the earlier releases Link to comment Share on other sites More sharing options...
G0rk0m Posted March 13, 2018 Share Posted March 13, 2018 9 hours ago, JwP said: Foxtrot, Thanks! it is working now. you would think the default would be setup to allow all .especially since it was not that way in the earlier releases I believe it was changed to help prevent collateral damage while pen testing. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.