Whistler Posted January 5, 2015 Share Posted January 5, 2015 i have the USB Rubber Ducky for two years and all of a sudden the SD reader would not work the chip set and the USB is fine but the reader would not work unless i press the end on the SD card to the bottom of the chip LED would be Green and runs the Script and if a leave it in the case or without pressure on the end of the SD card it would not Read no LED would be on - is there a way to change the SD read or desolder the old one and re-place it with a new one? Quote Link to comment Share on other sites More sharing options...
Broti Posted January 11, 2015 Share Posted January 11, 2015 (edited) Maybe it's just a contact problem. Have you tried to carefully clean the contacts? Edited January 11, 2015 by Broti Quote Link to comment Share on other sites More sharing options...
Whistler Posted January 12, 2015 Author Share Posted January 12, 2015 no i don't really know the best way to clean the reader Broti have any suggestions? Quote Link to comment Share on other sites More sharing options...
Whistler Posted January 12, 2015 Author Share Posted January 12, 2015 ok so i check there nothing inside but i do see one pin down does any what type of micro SD card Reader it is to replace it? Quote Link to comment Share on other sites More sharing options...
Whistler Posted January 12, 2015 Author Share Posted January 12, 2015 so i think i found the reader http://www.newark.com/amphenol-commercial-products/114-00841-68/memory-card-connector-microsd/dp/60R0752 i would order some and see how it goes wish me luck Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.