Tymac94 Posted June 16, 2009 Share Posted June 16, 2009 Recently my original antenna broke off the solder point. So i tried to solder it back on. Big mistake I am very inexperienced at soldering and well then I had a pile of melted solder on both of the points. I finally manged to melt it off and try and use a spare larger antenna(7 dbi magnetic) I striped the end down the the copper wire and soldered like so below. the circuit board is a little burnt and the wireless signal isn't all that great. Is this the proper way?. Quote Link to comment Share on other sites More sharing options...
Seshan Posted June 16, 2009 Share Posted June 16, 2009 Errr, it's hard to tell from the pics, but I think you did something wrong, can you get clearer pics and there should be two parts of the wire soldered on. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.