Pineapple Nano client mode?

[iffi]

I just bought a Pineapple Nano Tactical Elite. I don't understand how to wirelessly connect to an AP with the included USB WiFi thingy. I understand how to interface with it though. If somebody could tell me where I can instruct the Pineapple to use the third-party radio, that'd be great. Also, has anybody had trouble with their pineapple? My web interface tends to freeze after a few minutes on proper power (I've tried to factory reset a few times), it can only be temporarily fixed when I restart the Pineapple (and ssh works when it's frozen, weird huh?). Anyway, thanks for everyone's help in advance.

-Matt London

[thatalbinofrog]

Just get the radio and plug it in the back of the pineapple, wait till it flashes red then go to the networking tab, client mode and select wlan2, then scan. From there just enter the password for the router and connect to it. The Access points will then have internet access.

As for the interface, mine is fine. Try a factory reset if needed.

Hope this helps

Edited July 5, 2017 by thatalbinofrog

[iffi]

On 7/5/2017 at 1:26 PM, thatalbinofrog said:

Just get the radio and plug it in the back of the pineapple, wait till it flashes red then go to the networking tab, client mode and select wlan2, then scan. From there just enter the password for the router and connect to it. The Access points will then have internet access.

As for the interface, mine is fine. Try a factory reset if needed.

Hope this helps

Thanks so much, I can't believe I didn't see that setting!

I think I fixed the freezing problem too.