lallous
-
Posts
7 -
Joined
-
Last visited
Everything posted by lallous
-
RT @honorary_bot: Released an initial version of SDK for PulseDbg https://t.co/OYILjhl9t6 Who knows, might be useful for you ;)
-
@ReneFreingruber Fun find. If I knew about this earlier, I would have mentioned it in my #Batchography book ;)
-
@bcrypt The trick I guess is to stop trying (for a while, get your mind of it) to guess lest you build new muscle m… https://t.co/uzw8pXiBFw
-
Here's the walkthrough for the LichKing CTF challenge I posted a while back: https://t.co/Jgi3ztLGBX. Contains lots… https://t.co/DDD3E84ICP
-
@deddebme @angealbertini Good that you noticed Alfred. I have been using Source Insight since 2008 now (at least).… https://t.co/ILxeAPd4cG
-
RT @StarCraft: StarCraft 2 is going Free to Play! Campaign: Wings of Liberty Free Commanders: Free to lvl 5 Ranked: Free Unlock ? https://…
-
RT @xoreaxeaxeax: new project: sandsifter x86 processor fuzzer; exposes hidden instructions in x86; https://t.co/pefTtuHt88 https://t.co/k6…
-
RT @allowe: Hot blonde: "Doc, my memory's shot. I can't remember anything!" Dr.: "Just take off all your clothes and lie down. I'll see wha…
-
As simple as it sounds as a solution: it works. Thank you
-
RT @seattletimes: Mount St. Helens erupted in spectacular fashion on this day in 1980. Photos from our archive: http://t.co/WGJqziXLg1 http…
-
Hello, I forgot my root password so I factory reset the device. Now I navigate to 172.16.42.1, to get the [First Screen] I click continue and it takes me to a page to set a new password. After I set the new password, this screen shows up: Then a "Finish" button appears. I click it and then it takes me back to the first screen. It asks me to enter a new password again. I never managed to have it save the password and operate normally. All the DIPS are up but the device never moves away from the setup phase! Any advise?
-
ping?
-
RT @WIRED: Everything that happened in 2013 in one image http://t.co/IXYjXZxz9d http://t.co/5YbmHlyqr0
-
Hello, Thank you all for your answers. @Scott: your articles were very useful by the way. Thanks. Guys, shortly, what is Karma exactly (excuse my beginner question)? Thanks, Elias
-
Thanks for the reply. What I want is to redirect to another machine where Burp is running. In the command you showed me, it does not seem to say what host should the REDIRECT redirect to. Essentially, this is what I want: Clients connected to Mark 5 -> Mark 5 with iptables rule for redirecting port 80 to -> Windows machine (172.16.42.42) that is running Burp Is it possible to SSH into Mark 5 and configure it in such a way? Thanks
-
Hello, I have a Win7 machine that is acting as the gateway for the pineapple wifi. On the same machine, I installed Burp and have it listen on all interfaces at port 8080. How can I add a routing rule (iptables?) in Mark5 so it redirects all traffic to the Burp machine on 172.16.42.42? Thanks
