Jump to content

neep3r

Active Members
 View Profile  See their activity

  • Posts

    8

  • Joined

  • Last visited

 Content Type 

Everything posted by neep3r

  1. neep3r
    Surprised there have been zero updates regarding Tango Mode... What happened?
  2. neep3r
    Yep, things are working now. Sweet!
  3. neep3r
    Here are my Pineapple's /etc/config/network settings now: Pineapple #1: config interface lan option ifname eth0 option type bridge option proto static option ipaddr 172.16.42.1 option netmask 255.255.255.0 option gateway 172.16.42.42 option dns 8.8.8.8 Pineapple #2: config interface lan option ifname eth0 option type bridge option proto static option ipaddr 172.16.42.2 option netmask 255.255.255.0 option gateway 172.16.42.1 option dns 8.8.8.8 I booted both up in the plug but don't see a network connection or the ability to utilize the second Pineapple's wireless cards. Are there additional steps I am missing? Thanks again :)
  4. neep3r
    Thanks newbi3, you rock! Yeah it looks like this will be solved with a flick of a dip switch. Looking forward to the next firmware :D
  5. neep3r
    I have two MKV Pineapples and the new Pineapple Plug that I'd like to configure to work together. I set the second Wifi Pineapple's IP to 172.16.42.2 (in /etc/config/network) while keeping the first Wifi Pineapple's default, at 42.1. I then connected both Pineapples to the Wifi Pineapple Plug and booted them up. At this point I'm not sure what to do, nor do I know for sure if the Plug setup is working properly. I'm guessing it will be much easier to run two Pineapples together in future firmware updates but if anyone has experience working with two Pineapples I'd love a push in the right direction, or where to find relevant instructions/resources. Thanks!
  6. neep3r
    Thanks dop3! I'll give it a whirl. Mr-Protocol: Are you referring to spa_supplicant? This is something I tried before posting my question but I didn't have any luck.
  7. neep3r
    I am looking for a way to do this from the command line. I want to use the built-in AR9331 and RTL8187 radios for monitoring and attacks (wlan0 & wlan1) while using the two additional usb radios as an access point that I can connect to and internet backhaul.
  8. neep3r
    I have 2 additional wireless adaptors connected to my MK5 and I need to connect wlan3 to a WPA/WPA2 wireless network. What command do I run to connect to a WPA/WPA2 wireless network? Interface Chipset Driver wlan0 Atheros ath9k - [phy0] wlan1 RTL8187 rtl8187 - [phy1] wlan2 RTL8187 rtl8187 - [phy2] wlan3 Atheros ath9k - [phy3]
×
×
  • Create New...