crypt0ace

Hey again. So I'm trying to do a firmware recovery so my Pineapple TETRA is working again. I held the reset button. Plugged in power. Held the reset button for 10+ seconds. Release the reset button. Connected both the USB Y cables to laptop and the other end to ETH1 port on the pineapple. The interface comes up in the adapters. Configured 192.168.1.2 and 255.255.255.0 static IP in windows to the RealTek adapter that pineapple brings up. Tried connecting to http://192.168.1.1 but the web page is not reachable. The yellow LED light on the pineapple is solid. I also tried connecting to the UART bridge. It shows up as COM3 (shows up as USB Serial Port COM3 if thats important). Used Putty to connect. The top shows COM3 - Putty but I dont see any output on the terminal. Presses ENTER as said but doesnt show anything. I dont think its a hardware issue since the UART is working and the adapter shows up as well. Any help is very much appreciated.

https://wiki.wifipineapple.com/#!troubleshooting.md Using this. Held for 10 seconds as well still no change.

Also if someone here have used it. Whats the difference between the WiFi Pineapple and Flipper Zero? Is it just the range? Are the attacks almost similar? Since the Mark VII seems to be out of stock. And cant find somewhere that will ship to Pakistan.

I tried that. Pressing the RESET button for 7 seconds. Lights dont change or flicker. All three seem to be solid (which is also the same as I plug it in). Set the IP to 192.168.1.2/24 but cant access the webpage. It also says a WiFi recovery mode. But the AP of Pineapple_xxxx never gets up.

So, I understand that. But right now Im using the adapter that came with it plugged into the wall. and the USB Y cable (both ends) plugged in my laptop. The adapter comes up but still no luck getting it to work and still network cable unplugged on the network manager. The UART port. I used the same Y cable that came with it and put in the UART port. A COM6 comes up in the device manager. Can I somehow try and do a recovery mode on the pineapple using it? Or how can I do a factory reset on the pineapple some other way. My company ordered it 2 years back and I just got my hands on it so Im not sure if its messed up or anything. Maybe a reset might help.

see above. forgot to quote.

ive tried putting both. solo and combined as well. the docs mention that there should be an AP up when the pineapple boots up which is also not working.

I got a Pineapple TETRA ( MK5.8 as it says in the back). I have it connected to my PC on the USB A port to the Pineapple with the other end. Here is an image for reference. I have added the IPs like so. IP: 172.16.42.42 Netmask: 255.255.0.0 DNS: 8.8.8.8. Image for reference: I cant seem to connect to the pineapple on http://172.16.42.1:1471. I cant ping it either. Right now the LEDs enabled are all three solid. The network cable also mentions its unplugged. Not sure if thats intended. Cant find anything on the book that came with it.

Ill check. Thanks!

Hello. I have a classic USB Rubber Ducky. I cant find the firmwares and how I can flash them on this. The github repo from darren seems to be deleted. Right now I believe it has the Twin Duck firmware because I can put the inject.bin file in it and when I replug it it works but also opens it up as mass storage. If there is any, please link me to the classic rubber ducky wiki as well. Thanks!