SecretSquirrel Posted July 6, 2023 Share Posted July 6, 2023 Hi Everyone! My BB has been working fine for the last year with lots of interesting pentests done. Today I was programming it for another job and when I plugged it in and got a blue LED which came on for about 0.5 sec and then a steady green for as long as it was plugged into the USB of my laptop. I cannot do a factory reset as the green LED does not turn off like it should as shown in the video and instructions. Also, it does not matter which position the switch is in, it does the same as above. Could someone point me in the right direction to get it going again. Thanks, James Link to comment Share on other sites More sharing options...
dark_pyrro Posted July 6, 2023 Share Posted July 6, 2023 Can you serial into the Bunny when it's in arming mode? Link to comment Share on other sites More sharing options...
SecretSquirrel Posted July 7, 2023 Author Share Posted July 7, 2023 I cannot get into any mode, on any switch position the LED blinks blue as I put the device into my USB port and then stays green. Link to comment Share on other sites More sharing options...
dark_pyrro Posted July 7, 2023 Share Posted July 7, 2023 So, in what way did you try to serial into the Bunny? Link to comment Share on other sites More sharing options...
SecretSquirrel Posted July 7, 2023 Author Share Posted July 7, 2023 I don't know how to make it any clearer, I cannot do anything with the BashBunny as the green LED is on constantly and there is nothing I can do with it which includes serialing into it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.