LPinstaller Issue

[Sector.Xero]

This is my first post. First off. Hak5, you guys really know your stuff. Very admirable. This USB project is quite intriguing.

For my nuubie question: Just like the title says

I can't get past the first initial step.

I have the LPinstaller.exe and the iso. I'm trying to flash the CD partition of the U3 with the modded version Hak5 provides. My problem is that it the status bar for the installation goes up to 100% and then just sits there. I've let it sit there throughout the night, but nothing.

I deny the LPinstaller access to the Internet because I figured the software being installed is on my hard drive? Should I allow it Internet access? Has anyone had the same problem? Any suggestions would be appreciated. Thanks.

[Sector.Xero]

250 views and no one can relate?

[Jen]

Try allowing it, or if you overcloak your cpu, dont' overcloak it. I had the same problem when i was overcloaking it

[ElevenWarrior]

Try allowing it, or if you overcloak your cpu, dont' overcloak it. I had the same problem when i was overcloaking it

same problem here, and i can't figure it out. somtimes its flashes sucessfully, but the Files aren't on the flashed partion.

[misfitsman805]

one question for you guys,are you using the LPinstaller you got from Sandisk's website or are you using Universal Customizer?

[ElevenWarrior]

one question for you guys,are you using the LPinstaller you got from Sandisk's website or are you using Universal Customizer?

okay I'm using the U3 customizer and I finally flashed the partion, but its not dumping the logs, is it possible I didn't config the modules right?