kittytenders

Yeah I left if and the LED is still solid green. Can't access it and any switch setting just results in the same solid green LED.

Yes I tried that and it was going fine but after the red and blue flashes to indicate a reset it gets stuck on a solid green LED. It does not reboot but went through everything else properly. I unplugged it and plugged it back in but no LED. Any idea what to do? I've done this reset method last night with no response and earlier and got the LED's to light up finally. I was getting ZERO leds last night. Weird. Anyway thanks!

Update: The device is now showing no LEDS on any of the switches. I am almost certain it is bricked.

Hello, I had purchased my Bash Bunny around a year or two ago and configured it and set it all up and nearly forgot I had it. Recently I have been trying to get this thing to properly work. Here is what I am dealing with here. 1). In arming mode the bash bunny is not detected by my PC and I can not access the device. 2). The device takes about 7 or 8 seconds to boot. During this time no LED is presented however shortly after a solid green light is held and does not disappear. 3). I did not understand what the blinking blue and red LED meant and might have bricked it.