l0pus1

I also tried today to use my Windows 10 boot image and set up windows ICS per the following document: https://wiki.wifipineapple.com/#!connectivity.md The results were identical. The Tetra can't find the internet, and the Tetra's routing table remains unchanged.

I'm having issues with something which seems like it should be pretty simple, and hoping someone can help. I've connected my Tetra using the Y cable, which is mapping to eth1 in Kali. I've set the IP for eth1 to 172.16.42.2/24. I can connect to the Tetra settings page in my browser with no problems. When I use wp6.sh and use the guided setup, everything seems to be fine and it says it saves the config. When I try to connect using the settings I saved, I get this: Detecting WiFi Pineapple.............................................................................................

As indicated in my post, I followed all instructions in the video you posted. I'll repost in the Tetra section. Thanks.

One thing I looked at is the routing table on the Tetra. Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface default 172.16.42.42 0.0.0.0 UG 0 0 0 br-lan 172.16.42.0 * 255.255.255.0 U 0 0 0 br-lan I'm not sure that's right. Also of note - if I set the eth1 to get an IP assigned automatically, the pineapple assigns it an address in the 172.16.42.0/24 network, and only connections to the pineapple can be had. If I set the interface settings manually, I mus

I hope this is a simple and stupid fix. I've searched the forums here and haven't found anything helpful. I've connected my Tetra using the Y cable, which is mapping to eth1 in Kali. I've set the IP for eth1 to 172.16.42.2/24. I can connect to the Tetra settings page in my browser with no problems. When I use wp6.sh and use the guided setup, everything seems to be fine and it says it saves the config. When I try to connect using the settings I saved, I get this: Detecting WiFi Pineapple.............................................................................................

Thanks, Darren! Now I have something fun to do this afternoon. 😄

Not to double post, but I just bought this hardware in an unopened box completely unused, and to have a piece of networking hardware that's completely useless after support has been EOLed is fairly unprecedented. There has to be a way to make this usable. The hardware is fine.

So is it official then? I have a paperweight that can't load infusions? There's no way to load these manually?