Jump to content

Kook

Members
  • Content Count

    5
  • Joined

  • Last visited

About Kook

  • Rank
    Newbie
  1. Ok. Finally it worked. I disabled my wifi on my laptop and reset the pineapple again and bam. I tried that 2 times before but I guess my laptop adapter was enabled and caused some sort of conflict. Thanks for the speedy replies.
  2. I unplugged pressed and held button as I inserted back into my laptop and released the button 10 seconds after it was plugged in.
  3. So I tried setting my laptop wifi adapter to 192.168.1.2 and the nano to 192.168.1.1 and that didn't work. Also I disabled my laptop wifi and set the nano to 192.168.1.2 per firmware recovery instructions and then tried to go to 192.168.1.1 on my browser and nothing. I can ping 192.168.1.2 but not 192.168.1.1 I get the message: Pinging 192.168.1.1 with 32 bytes of data: Reply from 192.168.1.2: Destination host unreachable. Reply from 192.168.1.2: Destination host unreachable. Request timed out. Reply from 192.168.1.2: Destination host unreachable. Ping statistics for 192.168.1.1: Packets: Sent = 4, Received = 3, Lost = 1 (25% loss),
  4. I've tried disabling my wifi of my laptop adapter so it wouldn't connect to the router and still can't connect. Do i have to set the wifi pineapple nano to 192.168.1.2 or can it be some other address?
  5. I can't connect to my wifi pineapple nano. I was able to connect to it before but I was experiencing some problems so I decided to do a firmware recovery. I followed the instructions: Next, follow these steps to access the recovery web interface and update the firmware. Unplug the WiFi Pineapple completely from all power sources. Begin holding the RESET button on the device. With the RESET button held, power on the device. Continue holding the RESET button for 10 seconds, then release. NANO: The blue LED will remain solid TETRA: The yellow LED will remain solid Connect the host PC to the WiFi Pineapple via the USB Ethernet Port NANO: The male USB A plug TETRA: The Micro USB port labeled ETH From the host PC, configure a static IP address on the WiFi Pineapple facing Ethernet interface to 192.168.1.2 with netmask 255.255.255.0 For example, in Linux run ifconfig eth1 192.168.1.2 netmask 255.255.255.0 up (where eth1 is the interface name of the WiFi Pineapple). From the host PC, browse to http://192.168.1.1 Click Choose File and select the factory firmware image downloaded above. Click Update Firmware. This process will take several minutes. Do not interrupt the power supply while the firmware is updating. Once complete, the WiFi Pineapple will restart. Reset the the WiFi Pineapple facing USB Ethernet interface back to DHCP or 172.16.42.42 with netmask 255.255.255.0 But when I try to connect to it via 192.168.1.1 it goes to my router login. Please Help. What am I doing wrong?
×
×
  • Create New...