Jump to content

Gargamel

Members
  • Content Count

    3
  • Joined

  • Last visited

About Gargamel

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Thanks for the advice, yeah I will wait on the adapter. Are you aware if Hak5 sells the power adapters as well?
  2. I have followed the steps from https://docs.hak5.org/hc/en-us/articles/360010471774-Firmware-Recovery. I am able to access http://192.168.1.1 to upload "tetra_factory.bin" . After doing so, the pineapple gets into a loop of no LED light, followed by blinking blue light for approximately 1 minute, followed by approximately 20 seconds of a solid yellow light before starting over. Could this be a power issue? I seem to have lost the original ac adapter over the years and have ordered a new one. So it is only powered via the micro USB cable connected via eth1 port. Any suggestion
  3. I assume you have figured it out by now, but if not, granted you have already done the initial setup for the Pineapple, All you need to do is sign into the Management AP of the Pineapple with your Ipad / Iphone, then you can navigate to http://172.16.42.1:1471 using Chrome or Safari. This should get you to the Sign in Page of the Pineapple.
×
×
  • Create New...