word2yamutha
-
Posts
7 -
Joined
-
Last visited
Posts posted by word2yamutha
-
-
I dont have any any warning icons listed under "other devices."
-
19 hours ago, Cpt.Pickles said:
On switch 2 remove STORAGE, save , and follow the instructions here http://wiki.bashbunny.com/#!./index.md#Sharing_an_Internet_Connection_with_the_Bash_Bunny_from_Windows to remote into it.
So I followed these instructions and I wasn't able to remote into the bunnybash at all. I shared my wifi to the bunny and set the ip address as 172.16.64.64. The device just shows disconnected and was never able to obtain an ip address.
-
I tried hitting enter put I still get a blank page with no response. I tried following the firmware recovery without any success. switch 3 boots up to USB device goes green then blinks blue. I tired switch 2 and it seems to run the default payload as it turns purple. Is there anything else that I can try?
-
Putty just goes to a black screen and doesn't display anything. Is there a way to put the device into recovery mode?
-
Hello. I was just wondering if anyone else has experienced this issue, since this is the first time I have used it. I checked device manager and Bashbunny is set to COM4 and Bits per second is set to 115200, data bits: 8, parity bit: No, Stop bit: 1 like it says in the readme file. I set it up the same in Putty and run it as admin. It just loads to a black screen and nothing happens. I'm I missing something or did I get a defective device? Thanks
Unable to connect to serial via putty
in Bash Bunny
Posted
That didn't work either :(