Packet_Sniffer

That's the plan :)

None at all as it was very thorough, the issue being that I connected up the UART cable at the AP end, feeding it trhough a vent hole and screwing the lid down, which must have pulled the ground connector away from the board. Of course, I didn't check that end :) Perhaps my only suggestion would be "if you get garbage output, it's a serial configuration issue" could be added to the wiki? Rule number 1 - Check the physical :)

I am indeed, and am now the proud owner of a full flashed and up-to-date pineapple. Now I just need to work out what I'm going to do with it... ;)

Ok, problem resolved. There I am checking and rechecking and swapping over the connections at the UART end, to find the ground at the AP121U end wasnt mated properly. Thanks for the quick input. Next step... :)

Hello, First post as fallen at first hurdle. I've searched, read and researched, finding nothing that matches my issue. New Ap121U, with CP2102 UART configured. All settings checked and double checked against Mr Protocol's tutorial. All I get is garbage back from the Putty session: Slightly disapointed that I've fallen at the first step, as everything past this point seems pretty within my means. Thanks in advance for any guidance.