[Stock after setting passwor]

Hi,

Received my Mark 5 today and got an big smile . First i was looking confused around for the sd card but then I notice, that it was in the device itself. - So far, so good. Power it up with the power supply and connect using ethernett, got to the "change password" page and set a password like: eTske?cCr)t8 (example). Then to the next page with wait and blah-blah. After 20 minutes it's at same page but can see, that I lost the ethernet connection and that the wifi isn't available anymore.

I have an steady Red, Blue, Yellow (blinking slow) and Green.

Red - Solid [md5sum mismatch]

Blue - Solid (I guess it's flashing but that have been steady for over 20 minutes)

Yellow - Solid (except bliking once in a while).

Green - Solid light (The fruit got the needed juice)

- So what do I do? I have already downloaded the newest firmware from the web and placed it on an SanDisk Extreme 16GB MicroSDHC but can i just take out the card there came with the Pineapple and try pull the plug and set it to power again with the new sdcard or bad idea? - Thanks.

Picture of the mentioned: http://ragelse.com/i/Z4RvWcb

[Can the Mk V be powered via the USB Interface ?]

Darren, Any idea as to when those cables will be in stock - I keep checking, and they're always reported as out of stock.

Thanks

Like St3v3 wrote, I also found this sold out. But any "USB to 5.5mm / 2.1mm 5V DC Barrel Jack Power Cable" should work right? - Ask because a +1,5 meter wire would match better, what I have in mind.