[DIY Wifi Pineapple]

Make sure you buy the Firmware developer kit to program your ap121, you will also need serial to USB.

http://www.data-alliance.net/servlet/-strse-710/Developer-Kit-for-Hornet-dsh-UB/Detail

Or you could buy the ap121 with open wrt on it.

http://www.data-alliance.net/servlet/-strse-667/Alfa-AP121U-802.11n-AP-fdsh-Router/Detail

I had bought the ap121 with out open-wrt on it, so I had to by the developer kit to program it.

Data Alliance is a great US source to by from, have not had a problem with them.

[Alfa AP121U router]

Just using TX, RX AND GRD only. I did cross the tx and RX no luck. The alfa board looks like it might be the only way to go. I will try VMware tomorrow. If it does not work I will order alfa board.

Thanks

[Alfa AP121U router]

I will give that a try tomorrow.do you think a Developer Kit for Hornet would make difference?

Thank you.

[Alfa AP121U router]

This has been going on for the last two days. I've powered on and off to no luck. I've read everything I have found about flashing the device and this is my last resort. I'm using window 7 x64. The divers I am using for the com are x64.

[Alfa AP121U router]

I'm starting to wonder if serial ttl is bad. But no way of test it.

[Alfa AP121U router]

I've double and triple checked the baud and flow. I can't figure it out, I'm total lost. What would cause all the gibberish on the putty screen.

[Alfa AP121U router]

I get a lot of gibberish with putty when I power up my ap121u with hornet board. I've double checked all the settings in putty and made sure I set the ip correctly. The ap121u hornet has alfa software on it if that makes a difference.

[Alfa AP121U router]

I have Alfa AP121U router, Serial TTL Cable which I bought from Hak5. When I use the serial TTL to flash do I connect the USB end to the computer or the Serial TTL to a USB to serial Port cable then to the com port on computer? I have had no luck with flashing doing either. I have gotten lots of gibberish from trying the USB to computer.

Help please.