[Remove/Replace non-U3 CD Partition from USB drive]

I tried this version of UT165 UFDUtility v3.2.4.0 and i didn't try the version of the soft that U send with the link http://www.mediafire.com/file/yzvzqmg2z3z/UFDUtility.7z

because it was impossible to be extracted from WinRar or 7zip. Anyway i tried "Autorun Manager" and the device cannot be found by the utility.

When i tried MPTool (UT163 Multi-Devices Production Tool) v3.9.80.0 and other version of this soft, I followed these steps:

1. I installed the MDPT tool

2. I connected the flash (USBest) and the device was recognized as FABULK device.

3. I pressed F3 to Enumerate the ports

and when i pressed start, shows the code 0xa2 with 0MB capacity

With UT165 MP Tool 1.65.25.0 the same thing but when i pressed start the code changes from 0x12 0x28 to 0x12 0x28 0xa2 always with 0MB

With Super Stick Recovery Tool V1.0.2.19 it shows the size of flash drive 0MB

I think that is a broken drive but i need help for another device if U can with the following information by Chip Genius v2.64

Device Name: USB Mass Storage Device(USB DISK 30X USB Device)

PnP Device ID: VID = 13FE PID = 1D00

Serial Number: 5&&2B17EFFA&&0&&3

Revision: 1.00

Device Type: Standard USB device - USB2.0 High-Speed

Chip Vendor: phison(??)

Chip Part-Number: UP8/UP10 --------> chip Genius V3.0: UP13

Product Vendor: USB

Product Model: DISK 30X

I tried many utilities:

Phison UP13 UP14 UP12 V1.96, MP2232 V1.06, MPALL v2.01.00 (recognize the device but shows a mesagge "Flash Status Error") and all of these utilities show the capacity 0MB. I think that may be exist a solution to fix the problem because when i try with Acronis Media for Workstation can recognize the device and even can be formatted but when I plug in it again and try to access shows me a message "Please insert disk into drive". Please if you have any solution

please inform me. Thanks for your help and Happy New Year 2010. Best regards

Try using this tool... Low level format.

http://www.mediafire.com/?tpacci0rx4t0ihl