misteriously behaving new bunny
I have recently started playing around with my new bashbunny, and payloads. Can't figure out what I see when running my first basic payloads on Win7. Take this for example...:
Here is a payload I wrote, where I am trying to use ducky script commands and at the same time use the storage on the bunny, e.g. to store stuff on it later while running ducky commands.
Here is my payload for switch1:
#!/bin/bash
# Set LED Red while setting up attack
LED R
ATTACKMODE HID STORAGE
Q D
If you have access to your Bash Bunny, the correct way to perform a factory reset is the following:
Boot the device in ARMING mode
Serial into the device and execute "udisk reformat". The storage partition will now be formatted and the device will reboot
Serial into the device and execute "factory_reset_bunny". The Bash Bunny will reboot and be restored to firmware v1.0
Download and upgrade your Bash Bunny to the latest firmware version
You should be ready to go a
