Jump to content

Question regarding Bash Bunny setup


Jimmy2000

Recommended Posts

Posted

Good afternoon all...

Received the Bash Bunny Mk 2 in the mail today and have been unable to successfully deploy any payloads.

I am not using an SD card. 

First, I tried to copy the below script into the 'payload.txt' file in the switch1 folder.

ATTACKMODE HID
LED G R
Q DELAY 5000
Q GUI R
Q DELAY 500
Q STRING notepad
Q DELAY 500
Q ENTER
Q DELAY 2000
Q STRING "Hello World"
Q DELAY 500
Q ENTER
LED B R
ATTACKMODE RNDIS_ETHERNET
LED G

 

Next, I ejected the bash bunny and switched to switch1. I plugged in the bunny and nothing happened. I also tried to ping 172.16.64.1 and did not get a response.

I can, however, ssh into the device with the username as root and the password as hak5bunny.

I also tried to download impacket and copy to the 'tools' folder when in arming mode. After copying the file, I ejected and waited 5 seconds, then plugged back in. The bash bunny flashed magenta for 2 minutes, then the device was discoverable again. However, when looking back into the 'tools' folder, it is now empty.

 

Any help would be greatly appreciated.

 

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...