Jump to content

Power brick for the Mark7


Recommended Posts

Anything producing 5 volt/2 amps (as the documentation states). I use several different ones, either it be a powerbank or different kinds of power supplies. Usually using a 5V/3A one, but also Raspberry Pi official ones (either for the RPi 4 with USB-C directly or using an adapter from Micro USB to USB-C for older variants) or other ones with the correct amps. I'm using some with lower output as well since the Mark VII many times can run all OK with less amps (with not that much stress/load applied and a 5 GHz USB WiFi adapter, I've "clocked" it at about 0.6A).

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...