Mehr Posted February 10 Share Posted February 10 hi, my PineAP always Disabled , when I enable it everything fine but when I navigate to (Networking) page just open the page no action taken , then go back to PineAP page it get Disabled, then I can't enable it again only if I reboot the device ! PineAP Daemon: Disabled please help Quote Link to post Share on other sites
Danber Posted February 17 Share Posted February 17 buen día a mi me pasa lo mismo, agradecería cualquier ayuda Gracias Quote Link to post Share on other sites
Ingix Posted March 30 Share Posted March 30 Hey, I've had the same issue for awhile, I recently noticed that having no sd card in resolves my issues. While I may be late to the thread I will reply with updates if I ever have the time to figure it out. Quote Link to post Share on other sites
chrizree Posted April 1 Share Posted April 1 Do you have any experience involving problems with the SD card itself or has it worked as intended? I just started my Nano up after a long time not using it (just using the Mk7 nowadays) and I have no problems with either the SD card (as other have reported over time in the forum) or that PineAP refuse to stay enabled. It runs as expected. In what way are you powering the Nano? Does it get enough "juice" to make everything run problem free? Quote Link to post Share on other sites
Ingix Posted April 5 Share Posted April 5 I typically power the nano using the USB Y cable that it came with. The SD card itself will typically load pretty slowly, tested with two different SD cards too so I think it's just slow. I was considering a reflash to be safe, but I want to figure it out the issue before I try that. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.