gvoid23 Posted July 13, 2020 Share Posted July 13, 2020 So I setup the wifi pineapple tetra as it instructs and for a test run I try to connect a device to the open wifi. "Authentication problem". Oh silly me I forgot to add the MAC address to the filter "Authentication problem". Maybe if I try turning it off and on again and re-add the MAC address "Authentication problem". Maybe I redo the whole thing with a factory reset and then add both MAC address of device and SSID "Authentication problem". Maybe if I re-flash the firmware "Authentication problem". Alright let's try it on 3 different computers "Authentication problem". Different cables? "Authentication problem". Different place in the space time continuum with all previous attempted options? "Authentication problem". What have I done wrong? ); Link to comment Share on other sites More sharing options...
Olaf Mufjay Posted July 13, 2020 Share Posted July 13, 2020 what about your allow or deny? there are these two files in / etc. In the graphical web application you would have to be able to set this too. Unfortunately I don't have any pineapples with me at the moment to be able to look but I suspect that this should be found under Settings Link to comment Share on other sites More sharing options...
Irukandji Posted July 13, 2020 Share Posted July 13, 2020 It's in the filters area, Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.