Jump to content

Failed Initial Set up now i cant connect to it


Recommended Posts

I just got my Nano today and when i was in the middle of doing the firmware update it crashed and now i cant connect to it to finish the initial set up


Bus 001 Device 017: ID 0b95:772a ASIX Electronics Corp. AX88772A Fast Ethernet

ifconfig | grep enx00c0caa9958e

enx00c0caa9958e: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        ether 00:c0:ca:a9:95:8e  txqueuelen 1000  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 120  bytes 23165 (23.1 KB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...