Jump to content

Switch problem


granstr0m

Recommended Posts

Hi!

I just updated the BB to 1.6 and installed some tools. Now it seems it´s always in arming mode. It does not matter in which position the switch is.

Any suggestions?

Could the switch really be broken (hardware)? It worked just before I upgraded it.

/Christian

Link to comment
Share on other sites

1 hour ago, granstr0m said:

Could the switch really be broken (hardware)? It worked just before I upgraded it.

if you reset the bunny does the issue still happen? https://docs.hak5.org/hc/en-us/articles/360023739914-Factory-Reset

Link to comment
Share on other sites

23 minutes ago, granstr0m said:

Yes, I just factory reset it to 1.0 and still the same issue. The switch feels mechanically ok but I have obviously not broken myself in to the bunny... yet...

I actually got it to work with 1.0 after cleaning the payload directories. But as soon as I upgrade to 1.6 its the sam strange behaviour again.

Link to comment
Share on other sites

1 hour ago, granstr0m said:

I actually got it to work with 1.0 after cleaning the payload directories. But as soon as I upgrade to 1.6 its the sam strange behaviour again.

well, that's kind of good news. Deffo not hardware 🙂

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...