Jump to content

Recon scan repeatedly killing pineAP

Camaro ss

Recommended Posts

On my wifi pineapple nano, when starting a recon scan, it says pineap must be started. Then I start pineap with the button it pops up and then hit scan again. Pineap shuts down immediately and cannot run a scan. Sometimes recon does work, but most of the time it kills pineap. I've tried resetting it many times and I continue to have the same issue. I've had this issue since I got it I think a few years ago. Has been frustrating and I basically stopped using it. I noticed I was quite behind on firmware updates so I reset and updated the firmware thinking maybe it was a bug and updating would help. Nope. So now I'm back where I was at the beginning. Any suggestions are appreciated. I could use a hand. Thank you. 

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...