Jump to content

PineAP FAIL, Factory Image Hash Check FAIL


goingoutofbusiness

Recommended Posts

Can someone update the Factory recovery image to 2.42 since you have the hash matching 2.42 listed (the image is 2.41) and should the microsd be REMOVED or INSERTED when doing a factory recovery ??

After a factory flash everything works correctly first time, set PineAP to autostart set my log's to sdcard and do a reboot (using the option under CONFIGURATION > GENERAL) i'll close current web page tab while nano is in process of rebooting. After rebooted open up new tab check PineAP settings it hasn't started yet, enable on autostart is checked on. Also I've noticed the sdcard will sometimes say /dev/sd1 instead of /dev/sdcard/sd1 when unit takes a dump (microsd is sandisk ultra extreme class10) only been having these issue since updated to 2.4x firmware

And lastly YES THE Y cable is being used with both end's plugged in!

 

** Update: Ok so reflashed everything about 8th time, haven't changed the log location and everything seems stable now ??? Can I not point log saving to sdcard ???

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...