Jump to content
AlBaker

Payload won't complete after Twin Duck upgrade

Recommended Posts

The Twin Duck upgrade went fine and I the Rubber Ducky presents itself as mass storage after a second or so on the target computer. The problem is that the script only gets half done before it terminates and mass storage shows up. I've not found any way of allowing the script to complete. Can someone point me in the direction to where I can delay mass storage from showing up? Thanks

Share this post


Link to post
Share on other sites

Never mind - figured it out. I was trying to get the HID scripts done more quickly, but everything works fine if I increase the initial delay and the script starts after the mass storage is accessible. Thanks

Share this post


Link to post
Share on other sites

Would you mind sharing how you flashed the TwinDuck firmware?

Everything that I try, from c_duck_v2.1.hex over m_duck_v2.hex doesn't work. In fact the only firmwares working are the original and the usb.hex.

Is there any updated version of the Firmwares? Cause I couldn't find anything newer than 2015

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...