Baron Posted May 16, 2018 Share Posted May 16, 2018 I've been messing with my pineapple for a bit now and have decided to try it all out on the go. I cannot seem to find any sort of set up that doesn't result it from doing a boot loop from solid yellow to blinking blue to blank and repeat. Can someone else who has done this shed a little light for me? I have the Y cable with both ends in the Anker battery and the micro usb into the UART port, I have my android device connected to the ETH1 port, what am I doing wrong? Link to comment Share on other sites More sharing options...
b0N3z Posted May 17, 2018 Share Posted May 17, 2018 Ive noticed that even a little movement from the micro usb plugged into the tetra can cause it to restart. I also use 2 batteries with a single cable from each. one in eth1 and one in uart. Link to comment Share on other sites More sharing options...
Dave-ee Jones Posted May 17, 2018 Share Posted May 17, 2018 3 hours ago, b0N3z said: Ive noticed that even a little movement from the micro usb plugged into the tetra can cause it to restart. I also use 2 batteries with a single cable from each. one in eth1 and one in uart. Probably the cable being dodgy - the one I got with my BB was the same. My phone did it with it's cable as well (just got another cable, works fine). Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.