bolus Posted January 21, 2018 Posted January 21, 2018 I've reset my Lan Turtle, installed the latest firmware and am now looking at the netcat reverse shell. If I start/stop it manually then everything works fine, but if I set Bootup Status to Enabled, when I reboot, the setting is retained but the module hasn't actually started. Any suggestions where to look or what to do? Any logs that will assist in solving the problem? Cheers
bolus Posted January 23, 2018 Author Posted January 23, 2018 @Darren Kitchen and @Sebkinne Are there any logs I can tail, or configs that I should look at to diagnose this problem? I'm using latest firmware V4. Thanks in advance
bolus Posted January 28, 2018 Author Posted January 28, 2018 Update: I manually reset the Turtle today using latest firmware, re-downloaded modules. Same story, when a module is set to auto start, they don't actually start. Has anyone else experienced this issue lately? It's been a frustrating week of this so any suggestions or pointers will be gratefully received.
jaybeanz Posted October 15, 2018 Posted October 15, 2018 Im also having the same issue of modules not auto-starting. Have you found a solution as of yet?
Recommended Posts
Archived
This topic is now archived and is closed to further replies.