Jump to content

Archived

This topic is now archived and is closed to further replies.

Ruiner

Constant RED LED

Recommended Posts

I've had my new USB Rubber Ducky for a couple weeks now. It worked twice, then after I upgraded the firmware it stopped working. I reflashed everything going on the directions located online that involve manually updating the Atmel driver and running the program.bat duck_v2.1.hex command. Everything comes back fine. Everything encodes fine. Everything goes on the card fine. But when I stick the SD card into the ducky and then put it into the computer, even with a simply hello world, nothing happens and the red LED is solid on. Any help would be very much appreciated. I have a second one on the way to see if I can get this next one to work. It should be here by the end of the week but I'd like to have more than a $45 pretty board.

Share this post


Link to post
Share on other sites

OK some progress at least.... I re flashed it with c_duck_v2.1.hex and now I am getting a green/red blinking LED but the payload still does not run.

Share this post


Link to post
Share on other sites

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...