Ruiner Posted October 29, 2017 Share Posted October 29, 2017 I've had my new USB Rubber Ducky for a couple weeks now. It worked twice, then after I upgraded the firmware it stopped working. I reflashed everything going on the directions located online that involve manually updating the Atmel driver and running the program.bat duck_v2.1.hex command. Everything comes back fine. Everything encodes fine. Everything goes on the card fine. But when I stick the SD card into the ducky and then put it into the computer, even with a simply hello world, nothing happens and the red LED is solid on. Any help would be very much appreciated. I have a second one on the way to see if I can get this next one to work. It should be here by the end of the week but I'd like to have more than a $45 pretty board. Quote Link to comment Share on other sites More sharing options...
Ruiner Posted October 29, 2017 Author Share Posted October 29, 2017 OK some progress at least.... I re flashed it with c_duck_v2.1.hex and now I am getting a green/red blinking LED but the payload still does not run. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.