Jump to content
based

Unrecoverable?

Recommended Posts

Hey guys,

Followed the wiki to install the latest firmware manually, waited and after about ~15-20 minutes of waiting and seeing the LED was off, I touched it and it was blistering hot. 

I removed the bunny, and have proceeded to try every method or suggestion of recovery on this forum and under the sun. When I attempt recovery, it gets incredibly hot and after the red/blue flashed, it lights green for a second and then nothing. It isn't being detected by any of my machines, and I cant SSH into it or screen. I plug it in and it lights green for a second then goes off and will get hot if left in.

Anyone experiencing the same or have any suggestions? I've already submitted a ticket, but I wanted to make one more attempt to find a fix.

Share this post


Link to post
Share on other sites

Update: 

Doing some digging, and dmesg grep outputs show the device ACM0 is there as a mass storage device but i'm unable to locate the path.

So demsg shows the device is there, but screen and microcom can't connect.

I have suspicions that the firmware update which downloaded as as .tar should have been .tar.gz, so when i try to recover it tries to update with the missing file extension, and the overheating as it tries to update whenever i try to recover.

If this is the case, is there a way to access the bashbunny storage to remove the update file so it can recover properly?

Share this post


Link to post
Share on other sites

Anyone? Sorry to bump but supports not getting back to me :/

Willing to try anything to get it working

Share this post


Link to post
Share on other sites

I did a quick search of the Bash Bunny subforum. Go to the Bash Bunny subforum and type in 'hot' in the search bar. I suggest having a look through them - I think in most cases they needed to be replaced by Hak5 Support. Keep in mind they will probably be quite busy (there's only 2 people manning their whole support) with the upcoming event they're having so they may not reply for a few days (hopefully not too long).

Good luck!

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...