Quickcreds Stays on Red forever

[Nick5741]

I have updated to firmware version 1.3, and "installed" the tools (I dont know if they installed correctly or not) but I am still unable to run quickcreds. My test machine is a WIndows 10 laptop 64 bit system. Thank you in advance.

[PoSHMagiC0de]

According to the payload this happens when the bash bunny does not get and IP of the machine.

This payload looks to be updated to use firmware version 1.3 due to the GET extensions it is using.

It also uses responder, so.

Your bunny will need to be updated to firmware 1.3.

You will need to make sure you have responder installed, see the tools pinned post for the package and installation instructions.

With those, the quickcreds should go to yellow until you get creds.  

 

Other than that, maybe the machine is failing to install the RNDIS driver.  If you are running this on Windows make sure the RNDIS_ETHERNET attack mode is used, not ECM_ETHERNET.