George S Posted May 5, 2017 Share Posted May 5, 2017 Setting up my Tetra. Everything looks good except I cannot "switch" the PineAP Deamon to Enabled. Any suggestions? Quote Link to comment Share on other sites More sharing options...
b0N3z Posted May 5, 2017 Share Posted May 5, 2017 One your in the NANO section not the Tetra section. 2 how are you powering the device? Are there any other modules that you have set to autostart? Quote Link to comment Share on other sites More sharing options...
George S Posted May 8, 2017 Author Share Posted May 8, 2017 I have not added any other modules. What I am doing is following the Primer from YouTube after setting up the unit straight out of the box. Quote Link to comment Share on other sites More sharing options...
b0N3z Posted May 8, 2017 Share Posted May 8, 2017 are you using the wall power adapter to power the tetra or just the usb cable? Quote Link to comment Share on other sites More sharing options...
George S Posted May 10, 2017 Author Share Posted May 10, 2017 I have both plugged in... just to be safe. I wonder if I should reset and restart... Quote Link to comment Share on other sites More sharing options...
b0N3z Posted May 10, 2017 Share Posted May 10, 2017 that might not be a bad option, at least somewhere to start. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.