Jump to content

USB Rubber Ducky from Hak5 shop


vitbau
 Share

Recommended Posts

Hello,

I bought usb from Hak5 shop and can make it run the inject.bin as expected. Just it does not appear as flash drive. How can I make it both run the inject.bin and appear as flash drive so that user thinks that it is a normal thumb drive and does not know it acts like keyboard ?

Best Regards,

An

Link to comment
Share on other sites

It's not supposed to appear as a flash drive. That's the whole point. You plug it in, and it goes to work.

 

To make it appear as a flash drive, ie mountable, you need to have it open so you can press the button on it.

Edited by Rkiver
Link to comment
Share on other sites

  • 3 weeks later...
  • 4 years later...
On 11/22/2016 at 11:31 AM, Rkiver said:

To make it appear as a flash drive, ie mountable, you need to have it open so you can press the button on it.

What i did for one of my Rubber Ducky's is measure down from the end of the drive down to the button on the USB male end of the board with calipers. I put the drive back in the case, then measured that again and took a hot paperclip and made a hole in the case. This way I do not have to take the case apart to select the reset button. I mainly use it on my testing drive not my field drive.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...