Jump to content

Problem flashing Rubber Ducky in Kali


feners4
 Share

Recommended Posts

I connected my RB with button pressed. Ran the following code:

sudo ./dfu-programmer at32uc3b1256 erase

 

This apparently killed my USB hub or something. My USB hub setup had my Tp link, usb drive running live kali, and the RB. The hub stopped working after i ran the code and the result of it was a device not found. How can I flash the RB without damaging any usb hub or other usb devices? How can I test if RB is detected? Also, is there a chance of fixing the hub?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...