Jump to content

Recommended Posts

I can't even seem to connect to my new Nano 

there is no response on http://172.16.42.1:1471 

I plug it in - it boots - blue light blinks - then goes solid ...

My read of Ifconfig shows Nano is connected to en5 - but seems en5 has no IP address ???

Ifconfig output is below - and screen show is attached ... 

I'm stuck !!! Any ideas ?

Is there a way to Hard Reset ??  

 

-------------------------------------

en5: flags=8963<UP,BROADCAST,SMART,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu 1500

options=4<VLAN_MTU>

ether 00:c0:ca:8f:b6:11 

inet6 fe80::2c0:caff:fe8f:b611%en5 prefixlen 64 scopeid 0xa 

nd6 options=1<PERFORMNUD>

media: autoselect (100baseTX <full-duplex,flow-control>)

status: active

bridge100: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500

options=3<RXCSUM,TXCSUM>

ether 9a:e0:d9:79:10:64 

inet 192.168.2.1 netmask 0xffffff00 broadcast 192.168.2.255

inet6 fe80::98e0:d9ff:fe79:1064%bridge100 prefixlen 64 scopeid 0xb 

Configuration:

id 0:0:0:0:0:0 priority 0 hellotime 0 fwddelay 0

maxage 0 holdcnt 0 proto stp maxaddr 100 timeout 1200

root id 0:0:0:0:0:0 priority 0 ifcost 0 port 0

ipfilter disabled flags 0x2

member: en5 flags=3<LEARNING,DISCOVER>

        ifmaxaddr 0 port 10 priority 0 path cost 0

nd6 options=1<PERFORMNUD>

media: autoselect

status: active

 

 

pineapple-setup-stuck.pdf

Share this post


Link to post
Share on other sites

There is a hard reset on the bottom of the unit. Hold it in for about 10-15 seconds (i don't know the exact duration I just do it for this long) and resetup. The available video tutorials online make it extremely easy.

 

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...